搜索

官方微信

网站首页    走进龙驰    产品中心    新闻资讯    使用效果    技术服务    人才招聘    招商合作    在线留言    联系我们
地址: 江西省宜春市高安市兰坊镇   电话:13879568483(营销总监杨先生)   E-mail:longchishengwu@126.com
版权所有:江西龙驰生物工程有限公司               赣ICP备12005970号-1   

手机官网

  • banner

    banner

  • banner03

    banner03

  • banner02

    banner02

浏览量

DY-M586 (BLACK COLOR) GASKET MAKER

没有此类产品
我要询价
产品详细介绍
1. Properties & Applications
High temperature silicone sealant is developed by advanced technique. It is of one component, good sealing, resistance to high temperature and oil, weatherability, no flowing with vertical operation, no corrosion, low odor. It can replace a variety of rubber pads, asbestos mat, cork pad and paper pad to prevent leakage of water, oil, gas.
High temperature silicone sealant is applicable to automobiles, motorcycles, marine engines, gear boxes, fuel tank, construction machinery, chemical equipment, pipeline pumps, instrumentation, electronics industry, electrical devices, and also to flat flanges, pipe joints, sealing cover joints in other mechanical equipment.
 
2. Directions
  • Clear the contaminants like water, dusts, oil of the substrate surface to keep it clean, dry and smooth.
    Pierce the nozzle with the cap. Coat the gasket from the outer edge to inner edge at about 1.6 -3.2 mm thickness.
  • The surface of adhesive film will create reaction in about 10-20 minutes. Then press and tighten the two sealing sides.
  • It’ll take 24 hours to reach its maximum strength at room temperature 25℃.
  • Re-cap the tube after use. Wash your hands with water, and clean tools.
 
3. Storage & Warnings
 Storage:
  • Store the adhesive in shady, dry, well-ventilated, damp-proofing places。
  • Store the adhesive at room temperature.
  • Keep away from any source of ignition.  
 Warnings:
  • In the event of mass use, make a pre-test.
  • The adhesive is irritable to skin and eyes. 
  • Wear gloves while applying glue.
  • Keep out of reach of children.
  • In case of skin or eye contact, flush with water and seek medical treatment immediately if necessary.
 
4. Parameters

Color 

Elongation (%)

Filling Gap

Heat resistance

Touch dry 

Full cure 

Shelf life
﹙25℃﹚

Compressive Strength

Black paste

300

6mm

-60℃~+320℃

15mins~20mins

24hrs

12 months

10MPa

未找到相应参数组,请于后台属性模板中添加
暂未实现,敬请期待
暂未实现,敬请期待
关键词
上一篇
下一篇